Papers from JIM Fall Meeting (1998)

553-556: Difference of Crack Behavior Observed in Ti Films when Bend Testing of Ti-Coated Steel Sheets between the Films Coated on an (011)[100] Si-Steel Single Crystal and a Ferritic Stainless Steel

Yukio Inokuti

557-560: Local Atomic Structure in an Fe-B-Si Amorphous Alloy and Its Relaxation upon Annealing

Yoshihiro Takahara and Nobutaka Narita

561-564: Hydride Formation on Ti₃Al by Cathodic Hydrogen Charging in Sulfuric Acid Containing Sb₂O₃

Hideo Numata and Tokuzou Tujimoto

565-568: Effect of Au Coating on the Wettability of Cu Substrate by Sn-Ag Eutectic Solder

Hisaaki Takao and Hideo Hasegawa

569-572: Effects of Sintering Temperature on Corrosion Resistance of Titanium Alloys Prepared by Spark Plasma Sintering

Jun Onagawa and Yoshiyuki Sato

573-576: Molecular Dynamics Simulation of Core Structure of (c+a) Dislocations in HCP Metals

Shinji Ando, Takushi Goto, Kazuki Takashima and Hideki Tonda

577-580: Interfaces in Al₁₈B₄O₃₃/Al, Mg Alloy Composites

Gen Sasaki, Li Jun Yao, Makoto Yoshida, Jin Pan and Hideharu Fukunaga

581-584: Effect of Carbide and Nitride Precipitates on the Fatigue Properties of Fe-30 mass%Cr Alloys

Tadashi Fukuda

585-588: Morphological Effect of Secondary Recrystallized Grains on High-Temperature Creep of P/M Tungsten Fine Wires

Koji Tanoue and Hiroyuki Ogata

589-592: Analysis of Dynamic Grain Growth Behavior during Superplastic Deformation Using a Grain Boundary Diffusion Mechanism

Byung-Nam Kim, Keijiro Hiraga, Yoshio Sakka and Byung-Wook Ahn

593-596: Behavior of Hydrogen in an Ni₃Al Compound Investigated by means of Hydrogen Microprint Technique

Goroh Itoh, Naoki Haramura and Tomoaki Ihara

597-600: Constitutive Equations Describing Creep Curve of a Statically Aged Mod.9Cr-1Mo Steel

Kyu Seop Park, Fujimitsu Masuyama and Takao Endo

601-604: Material Factors in the Decrepitation of Hydrogen Storage Alloys

Takanori Suda, Ryouichi Kobayashi, Seiichi Watanabe, Somei Ohnuki, Heishitirou Takahashi, Hironobu Arashima and Toshiki Kabutomori

605-608: Microstructure and High Temperature Compressive Strength of Nb-Ir Alloys

Yi Tan, Hisao Tanaka, Chaoli Ma, Akio Kasama, Ryohei Tanaka, Yoshinao Mishima and Shuji Hanada

609-612: Corrosion Resistance and Nature of Surface Film on Fe-Si Alloy in Boiling Sulfuric Acid

Ikuo Ioka, Jyunji Mori, Chiaki Kato, Masatoshi Futakawa and Kaoru Onuki

613-616: Effect of Niobium or Vanadium Addition on the Microstructure and Hardness of MoSi₂-Mo₅Si₃Eutectic Alloys

Toshihiko Fukui, Shunkichi Ueno, Ryohei Tanaka, Seiji Miura and Yoshinao Mishima

617-620: Wear Resistance and Heat Resistance of Rapidly Solidified P/M Al-Ti-Fe-TM Alloys

Hidenobu Ohta, Makoto Takagi, Toru Imura, Yoshihito Kawamura and Akihisa Inoue

621-624: Characterization on the Electrical Properties of Copper Nitride Thin Films and the Effects of Hydrogen Implantation

Tsutomu Ishikawa, Masataka Masuda and Yasunori Hayashi

Regular Articles

625-633: TEM Observation of Grain Boundary Precipitates and Cr-Depleted Zone in 18 mass%Cr Steels

Shin Ishikawa, Mitsuyuki Fujisawa, Jun-ichi Shimomura and Kei-ichi Yoshioka

634-640: Sintering Characteristics of the MgO-Dispersed Ni Powder Reduced from (Ni, Mg)O

Katsuhiko Takahashi, Minoru Asada and Masahiro Kawakami

641-648: Influence of Crystallographic Orientation on the Strength of Ni-Base Superalloy Single Crystals at Temperatures above the Peak Temperature

Koji Kakehi

649-655: Solid State Amorphization and Electric Discharge Consolidation of Oxide Ceramics

Hiroshi Kimura and Kazuhiro Hongo

656-660: Single-Phase Interdiffusion in Intermetallic Compound Ti₃Al

Masahiko Kato, Hisaoki Sasano and Toshiyuki Suzuki

661-668: Properties of Y₂SiO₅ Oxidation Protection Coating for Carbon/Carbon Composites

Masayuki Kondo, Yuzuru Ogura and Tatsuo Morimoto

669-674: Mechanical Properties and Orientations of Zinc Single Crystal Wires Produced by the OCC Process

Genjiro Motoyasu, Hideki Kadowaki and Hiroshi Soda